Use este identificador para citar ou linkar para este item: http://repositorio.ital.sp.gov.br/jspui/handle/123456789/637
Título: Effect of pulse repetition rate and number of pulses in the nalysis of polypropylene and high density polyethylene by nanosecond infraed laser induced breakdown spectroscopy
Autor(es): Leme, Flavio O.; et al.







Palavras-chave: LIBS
Laser induced breakdown spectroscopy
Laser pulse repetition rate
Craters characterization
High density polyethylene
Polypropylene
Data do documento: 2012
Citação: Applied Surface Science, http://dx.doi.org/10.1016/j.apsusc.2011.11.122.
Resumo: Pulse repetition rates and the number of laser pulses are among the most important parameters that do affect the analysis of solid materials by laser induced breakdown spectroscopy, and the knowledge of their effects is of fundamental importance for suggesting analytical strategies when dealing with laser ablation processes of polymers. In this contribution, the influence of these parameters in the ablated mass and in the features of craters was evaluated in polypropylene and high density polyethylene plates containing pigment-based PbCrO4. Surface characterization and craters profile were carried out by perfilometry and scanning electron microscopy. Area, volume and profile of craters were obtained using Taylor Map software. A laser induced breakdown spectroscopy system consisted of a Q-Switched Nd:YAG laser (1064 nm, 5 ns) and an Echelle spectrometer equipped with ICCD detector were used. The evaluated operating conditions consisted of 10, 25 and 50 laser pulses at 1, 5 and 10 Hz, 250 mJ/pulse (85 J cm−2), 2 s delay time and 6 s integration time gate. Differences in the topographical features among craters of both polymers were observed. The decrease in the repetition rate resulted in irregular craters and formation of edges, especially in polypropylene sample. The differences in the topographical features and ablated masses were attributed to the influence of the degree of crystallinity, crystalline melting temperature and glass transition temperature in the ablation process of the high density polyethylene and polypropylene. It was also observed that the intensities of chromium and lead emission signals obtained at 10 Hz were two times higher than at 5 Hz by keeping the number of laser pulses constant.
URI: http://repositorio.ital.sp.gov.br/jspui/handle/123456789/637
Outros identificadores: 
Aparece nas coleções:Artigos Científicos

Arquivos associados a este item:
Arquivo Descrição TamanhoFormato 
Effect of pulse repetition rate and number....pdf1.33 MBAdobe PDFVisualizar/Abrir


Os itens no repositório estão protegidos por copyright, com todos os direitos reservados, salvo quando é indicado o contrário.